MELONSEED
13'4" - Built by Etienne Muller 2020 - Designed by Selway
Fisher
I
turned over the hull to finish off the centreboard
slot before starting on the deck. First I used a
bearing bit on the router to trim the ragged edges on
the rough cutout in the keel flush with the inside
walls of the case, then I rounded over the corner with
a quarter inch radius router bit. The flat keel makes
this operation very easy compared to other hull
shapes. There is a length of mini cell foam wrapped in
packing tape pressed down about an inch and a half
inside the slot to prevent epoxy running down inside
when I glass. |
